Pretest Inspection

CAUTION: Always turn ignition off before disconnecting any control module connector. Failure to do so could result in damage to control module. When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery.

NOTE: Do not use a test light in place of a voltmeter unless instructed to do so. Always disconnect scan tool before charging battery. Always perform appropriate verification test after repairs are made. See appropriate test under VERIFICATION TESTS .

Verify customer complaint. Inspect all system fuses. Check for loose accessory drive belt. Check all fluid levels. Check components for visible damage. Check components for loose/poor connections, corrosion and backed-out terminals. Check battery condition and battery terminals. Ensure charging system is operating properly. Check for damaged wiring. Check ground connections. See GROUND DISTRIBUTION in appropriate SYSTEM WIRING DIAGRAMS article in ELECTRICAL. Correct any obvious problems before continuing with testing. If no problems exist, go to SELF-DIAGNOSTIC SYSTEM .