LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> Intrepid Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0113: Intake Air Temperature Sensor High >> Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0113: Intake Air Temperature Sensor High: Testing

  1. Turn ignition on, engine not running. With DRBIII®, read the IAT voltage. Is the voltage above 4.6 volts? If yes, go to next step. If no, go to step  7.
  2. Turn the ignition off. Disconnect the IAT Sensor harness connector. Turn ignition on, engine not running. Measure the voltage on the IAT Sensor Signal circuit at the IAT Sensor harness connector. Is the voltage above 5.2 volts? If yes, repair the short to battery voltage in the IAT Sensor Signal circuit. If no, go to next step.
  3. Turn the ignition off. Connect a jumper wire between the IAT Sensor Signal circuit and the Sensor Ground circuit in the IAT harness connector. Turn ignition on, engine not running. With the DRBIII®, read IAT voltage. Is the voltage below 1.0 volt? If yes, replace the IAT Sensor. If no, go to next step.
    4. CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal-to-pin connection. Use Miller Special Tool (8815) when performing diagnosis at PCM harness connectors.
  4. Ensure ignition is off. Disconnect the PCM harness connectors. Measure the resistance of the IAT Sensor Signal circuit from the IAT Sensor harness connector to the appropriate terminal of the Miller Special Tool. Is the resistance below 5.0 ohms? If yes, go to next step. If no, repair the open in the IAT Sensor Signal circuit.
  5. Measure the resistance of the Sensor Ground circuit from the IAT Sensor harness connector to the appropriate terminal of the Miller Special Tool. Is the resistance below 5.0 ohms? If yes, go to next step. If no, repair the open in the Sensor Ground circuit.
    6. NOTE: Before continuing, check the PCM harness connectors for corrosion, damage or terminal push out. Repair as necessary.
  6. There are no possible causes remaining, replace PCM. Program the new PCM. See PROGRAMMING .
    7. WARNING: When the engine is operating, do not stand in a direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing.
  7. The conditions that set the DTC are not present at this time. The following may help in identifying the intermittent condition. With the engine running at normal operating temperature, monitor the DRBIII® parameters related to the DTC while wiggling the wiring harness. Look for parameter values to change and/or a DTC to set. Review the DRBIII® Freeze Frame information. If possible, try to duplicate the conditions under which the DTC was set. Refer to any Technical Service Bulletins (TSB) that may apply. Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals. Were any of the above conditions present? If yes, repair as necessary. If no, test is complete.
scientia non olet · About LEMON Manuals