Complete PCI Bus Failure
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). DLC is located on bottom of instrument panel, to left of brake pedal. See Figure . Turn ignition on. Using scan tool, attempt to communicate with all modules. If scan tool communicates with one or more modules, go to next step. If scan tool does not communicate with any modules, go to step 3 .
- Turn ignition off. If all modules communicate, test is complete. If one or more modules will not communicate, check PCI bus circuit wiring between DLC and affected module. See COMPUTER DATA LINES in SYSTEM WIRING DIAGRAMS article in ELECTRICAL. Repair wiring as necessary. If no problem is found and modules still do not communicate, diagnose using appropriate test. See SYMPTOM INDEX table under SELF-DIAGNOSTICS.
- Remove scan tool. Disconnect 40-pin Powertrain Control Module (PCM) connector C2. Using an ohmmeter, check resistance of PCI bus circuit between DLC terminal No. 2 and PCM connector C2 terminal No. 59. See Figure and Fig 1 . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open wire.
- Reconnect PCM connector C2. Turn ignition on. Measure voltage at DLC connector terminal No. 2. If voltage is more than 1.5 volts, go to next step. If voltage is less than 1.5 volts, go to step 6 .
- Turn ignition off. Using a voltmeter connected to DLC terminal No. 2, PCI bus circuit and ground, monitor voltage as each of the following modules are disconnected one at a time.
- Occupant Restraint Controller
- Sentry Key Immobilizer
- Remote Keyless Entry
- Mechanical Instrument Cluster
- Anti-Lock Brake System (ABS) Controller Anti-Lock Brake (CAB)
- Powertrain Control
If 1.5 volts or more exists after disconnecting all modules, repair short to voltage in wire. If voltage is less than 1.5 volts after disconnecting modules, replace suspect modules.
- Turn ignition off. Wait one minute. Using an ohmmeter connected to DLC terminal No. 2, PCI bus circuit and ground, monitor resistance as each of the following modules are disconnected one at a time.
- Occupant Restraint Controller
- Sentry Key Immobilizer
- Remote Keyless Entry
- Mechanical Instrument Cluster
- Anti-Lock Brake System (ABS) Controller Anti-Lock Brake (CAB)
- Powertrain Control
If resistance is less than 5 ohms after disconnecting all modules, repair short to ground in wire. If resistance is 5 ohms or more after disconnecting modules, replace suspect modules.
NOTE:
When performing this step, turn ignition off and wait one minute before disconnecting each module. After each module is disconnected, turn ignition on.