LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> Neon LE, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Instrument Cluster >> Foglight Indicator Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Foglight Indicator Inoperative

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Turn foglights on. If foglights are inoperative, repair as necessary. If foglights operate, turn ignition off. Disconnect 26-pin instrument cluster connector, located behind left upper instrument panel. Turn headlights and foglights on. Using a voltmeter, check voltage between instrument cluster connector terminal No. 4, foglight switch output circuit and ground. See Figure . If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, repair open on wire.
  2. Turn ignition off. Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in ANALOG INSTRUMENT PANELS article. Remove foglight Light Emitting Diode (LED) from instrument cluster. Using a DVOM, select DIODE mode. Connect DVOM Black lead to LED negative (-) terminal. Connect DVOM red lead to LED positive (+) terminal. If LED illuminates, replace instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION in ANALOG INSTRUMENT PANELS article. If LED does not illuminate, replace defective LED.
scientia non olet · About LEMON Manuals