No SKIM Messages Recieved
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
- Turn the ignition on. With the DRB, attempt to communicate with the SKIM. If the DRB was able to I/D or communicate with the SKIM, go to the next step. If the DRB was not able to I/D or communicate with the SKIM, diagnose and repair commubication problem. See SYMPTOM INDEX table in SELF-DIAGNOSTIC SYSTEM.
- With the DRB, erase DTCs. Turn the ignition on and wait approximately 1 minute. With the DRB, read DTCs. If this DTC reset, replace the remote keyless entry module. See REMOTE KEYLESS ENTRY MODULE under REMOVAL & INSTALLATION. If the DTC did not reset, the test is complete.