LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> Neon LX, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> Programming >> Powertrain Control Module >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module: Notes

NOTE: Before replacing the Powertrain Control Module (PCM) for a failed driver, control circuit or ground circuit, be sure to check the related component/circuit integrity for failures not detected due to a double fault in the circuit. Most PCM driver/control circuit failures are caused by internal failure to components (i.e. relay and solenoids) and short circuits (i.e. 12-volt pull-ups, drivers and ground sensors). These failures are difficult to detect when a double fault has occurred and only one DTC has set.
NOTE: If the PCM and the Sentry Key Immobilizer Module (SKIM) are replaced at the same time, program the VIN into the PCM first. All vehicle keys will then need to be replaced and programmed to the new SKIM. See SENTRY KEY IMMOBILIZER MODULE  .
NOTE: The Sentry Key Immobilizer System (SKIS) secret key data is an identification code that is unique to each SKIS. This code is programmed and stored in the PCM, SKIM and ignition key transponder chip. When replacing the PCM it is necessary to program the secret key data into the PCM
scientia non olet · About LEMON Manuals