Skis Verification Test
CAUTION:
Always turn ignition off before disconnecting or connecting any control module connectors. Failure to do so could result in damage to control module.
NOTE:
When entering the PIN, care should be taken because the SKIM will only allow 3 consecutive attempts to enter the correct PIN. If 3 consecutive incorrect PINs are entered the SKIM will lock out the DRBIII for one hour.
- Reconnect all previously disconnected components and connectors.
- Obtain the vehicles unique Personal Identification Number (PIN) assigned to its original SKIM. This number can be obtained from the vehicles invoice or Chryslers customer center (1-800-992-1997).
- To exit lock out mode, the ignition key must remain in the run position continually for one hour. Turn off all accessories and connect a battery charger if necessary.
- With the DRBIII, select THEFT ALARM, SKIM and MISCELLANEOUS. Then select desired procedure and follow the steps that will be displayed.
- If the SKIM has been replaced, ensure all of the vehicle ignition keys are programmed to the new SKIM.
- Prior to returning vehicle to the costumer, perform a module scan to be sure that all DTCs are erased. Erase any DTCs that are found.
- With the DRBIII erase all DTCs. Perform 5 ignition key cycles leaving the key on for at least 90 seconds per cycle.
- With the DRBIII, read the SKIM DTCs. If there art no SKIM DTCs present, repair is complete.