O2 Sensor: Operation: Notes

The O2 Sensors are zirconium dioxide, four wire and heated. The heater uses two of the sensors' four wires. One is common ground, the other provides battery voltage to the heater from the ASD Relay. One of the remaining wires is a sensor signal input to the PCM. The fourth wire is signal ground. The O2 Sensors deliver a voltage signal (0-1 volt) to the PCM inversely proportional to the amount of oxygen in the exhaust. If the oxygen content is low, the output voltage is high; if the oxygen content is high, the output voltage low. The O2 Sensors must have a source of oxygen from outside the exhaust stream for comparison. O2 Sensors receive their fresh oxygen supply through the wire harness. This is why it is important to never solder an O2 Sensors connector or pack the connector with grease.

The Automatic Shutdown (ASD) relay supplies battery voltage to both the upstream and downsteam heated oxygen sensors. The oxygen sensors are equipped with a heating element. The heating elements reduce the time required for the sensors to reach operating temperature. The O2 Sensor uses a Positive Thermal Coefficient (PTC) heater element. As temperature increases, resistance increases. At ambient temperatures around 21°C (70°F), the resistance of the heating element is approximately 6 ohms for the Downstream Sensor and is approximately 4.5 ohms for the Upstream Sensor. As the sensor's temperature increases, resistance in the heater element increases.