FCM, BCM Communication Fault
NOTE:
After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.
- Turn ignition on. Using scan tool, attempt to communicate with Body Control Module (BCM). If scan tool communicates with BCM, go to next step. If scan tool does not communicate with BCM, go to BUS +/- SIGNALS OPEN OR NO RESPONSE FROM BCM .
- Using scan tool, erase DTCs. Turn ignition off and back on. Wait a minimum of one minute. Recheck for DTCs. If DTC does not reset, test is complete. If DTC resets, replace Front Control Module (FCM). See FRONT CONTROL MODULE under REMOVAL & INSTALLATION.