Internal Driver Fault No. 2

NOTE: After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.

Turn ignition on. Using scan tool, record and erase Front Control Module (FCM) DTCs. Turn ignition off. Wait 10 seconds. Turn ignition on. Recheck for DTCs. If INTERNAL DRIVER FAULT NO. 2 resets, replace FCM. See FRONT CONTROL MODULE under REMOVAL & INSTALLATION. If INTERNAL DRIVER FAULT NO. 2 does not reset, conditions necessary to set this DTC are not present at this time. Check for intermittent poor connections or faulty circuits and repair as necessary.