LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2002 >> Voyager EC >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Power Liftgate >> Overhead Liftgate/Lockout Switches Short
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Overhead Liftgate/Lockout Switches Short

NOTE: After making any repairs, perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  1. Using scan tool, erase DTCs. Turn ignition off. Wait approximately 10 seconds. Turn ignition on. Operate liftgate from overhead console switch. Recheck for DTCs. If OVERHEAD LIFTGATE/LOCKOUT SWITCHES SHORT resets, go to next step. If OVERHEAD LIFTGATE/LOCKOUT SWITCHES SHORT does not reset, system is operating properly at this time. Check for intermittent poor connections or faulty circuits.
  2. Using scan tool, erase DTCs. Disconnect overhead console switch. Overhead console will need to be removed to access switch connector. See OVERHEAD CONSOLE  under REMOVAL & INSTALLATION. Turn ignition off. Wait approximately 10 seconds. Turn ignition on. Recheck for DTCs. If OVERHEAD LIFTGATE/LOCKOUT SWITCHES SHORT resets, go to next step. If OVERHEAD LIFTGATE/LOCKOUT SWITCHES SHORT does not reset, replace overhead console switch assembly.
  3. Locate and disconnect Body Control Module (BCM) connector C2. See COMPONENT LOCATIONS . See Figure. Using DVOM, measure resistance between ground and BCM connector C2 terminal No. 6 (Violet/Tan wire). If resistance is greater than 500 ohms, replace BCM. See BODY CONTROL MODULE  under REMOVAL & INSTALLATION. If resistance is 500 ohms or less, repair short to ground in Violet/Tan wire.
scientia non olet · About LEMON Manuals