LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2003 >> Intrepid SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> Using Odometer
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using Odometer

  1. DTCs can be retrieved by cycling ignition switch and viewing instrument cluster odometer display. To retrieve DTCs, cycle ignition key on-off-on-off-on within 5 seconds. If any DTCs are displayed, perform appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . After repair is complete, clear DTCs from Powertrain Control Module (PCM) and perform appropriate verification test. Verification tests are located at the end of the diagnostic tests.
  2. If no DTCs are displayed, odometer will display either P1684 and DONE, or only DONE. DTC P1684 is only a status and indicates that PCM memory has been cleared within the last 50 ignition cycles. No problem exists. DONE indicates that no DTCs are present and procedure is complete. If no DTCs are present go to one of the following:
    • For starting or driveability problems, go to appropriate TROUBLE SHOOTING - NO CODES article for diagnosis by symptom.
    • For speed control problems and servicing information, refer to appropriate CRUISE CONTROL SYSTEMS article in ACCESSORIES & EQUIPMENT.
    • For charging system problems, refer to appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS.
    • For transmission electronic controls system problems, refer to appropriate DIAGNOSIS article in AUTOMATIC TRANSMISSIONS.
scientia non olet · About LEMON Manuals