Window Motor: Installation
- Install new motor on regulator by positioning motor gearbox so that it engages regulator sector teeth.
- A slight rotational or rocking movement may be necessary to bring three motor gearbox screw holes into proper position.
- Install three gearbox screws and one tie down bracket screw, if applicable. Tighten to 5.6 to 8 N.m (50 to 70 in. lbs.) torque.
- Install regulator. Using the switch, test operation of motor.
- Install trim panel. Refer to appropriate TRIM PANEL installation procedure.
- Connect the negative battery cable remote terminal to the to the remote battery post.