LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2003 >> Intrepid SXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Body Control Modules) >> Removal & Installation >> Junction Block >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open hood and disconnect the negative battery cable.
  2. Open the front drivers door and remove left end cap.
  3. Remove 2 screws from lower instrument panel cover. Pull rearward on lower instrument panel cover releasing clips. Disconnect deck lid release switch wiring, cable to hood release and remove cover from vehicle.
  4. Remove left knee blocker.
  5. Remove under column ducts.
  6. Remove junction block 4 mounting screws.
  7. Remove wire harness connectors from junction block and remove junction block.
  8. Disconnect BCM wire connectors and RKE antenna connector.
  9. Remove junction block from vehicle. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals