Power Distribution Center: Removal

The Power Distribution Center (PDC) is serviced as a unit with the engine compartment wire harness. If any internal circuit of the PDC or the PDC housing is faulty or damaged, the entire PDC and engine compartment wire harness unit must be replaced.

1. Open hood.
2. Disconnect and isolate the battery negative cable.
3. Disconnect each of the engine compartment wire harness connectors. Refer to appropriate wiring diagrams for more information on the locations of the affected connectors.
4. Remove the fasteners that secure each of the engine compartment wire harness ground eyelets to the vehicle body and chassis components. Refer to appropriate wiring diagrams for more information on the ground eyelet locations.
5. Disengage each of the retainers that secure the engine compartment wire harness to the vehicle body and chassis components. Refer to appropriate wiring diagrams for more information on the retainer locations.
6. Disengage and remove the PDC housing from its mounting bracket.
7. Remove the PDC and the engine compartment wire harness from the engine compartment as a unit.