Fuel System Pressure Release Procedure
- Remove the fuel filler tube cap.
- Remove the fuel pump fuse from the relay control module (3) located next to the PCM.
Courtesy of DAIMLERCHRYSLER CORP.
- Start and run engine until it stalls.
- Attempt restarting engine until it will no longer run.
- Turn ignition key of OFF position.
- Return the fuel pump fuse to the relay control module.
- One or more Diagnostic Trouble Codes may have been stored in PCM memory due to fuel pump fuse removal. The DRB III® scan tool must be used to erase a DTC.