Sentry Key Immobilizer Module Programming

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2003 Jeep Wrangler, 2003 Jeep Liberty, 2003 Jeep Grand Cherokee, 2003 Dodge Viper, and 2003 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Large metallic objects, or items such as magnetic pass-keys, may cause vehicle starting problems. These devices do not cause damage to system. Devices may cause intermittent malfunctions if positioned too close to ignition lock cylinder during vehicle start-up. Move objects away from ignition lock cylinder and try to start vehicle.

NOTE: If the PCM and the SKIM are replaced at the same time, program the VIN into the PCM first. All vehicle keys will then need to be replaced and programmed to the new SKIM.

Connect scan tool to Data Link Connector (DLC), located under left side of instrument panel. Turn the ignition on (transmission in Park/Neutral).
Using scan tool, select THEFT ALARM, SKIM, then MISCELLANEOUS.
Select SKIM MODULE REPLACEMENT (GASOLINE).
Obtain 4-digit Personal Identification Number (PIN) from vehicle owner or manufacturer. Enter secured access mode by entering PIN code for vehicle.

CAUTION: Enter correct country code in SKIM. If incorrect country code is entered, SKIM must be replaced.

Select COUNTRY CODE. Enter correct country. Select UPDATE VIN. SKIM will learn VIN from Powertrain Control Module (PCM). Press ENTER to transfer secret key data from PCM to SKIM. This will ensure the current vehicle ignition keys will still operate the SKIS system.