Ignition Keys To Skim
- Turn the ignition switch on (transmission in Park/Neutral).
- Use the DRBIII® and select THEFT ALARM, SKIM then MISCELLANEOUS.
- Select PROGRAM IGNITION KEYS.
- Enter secured access mode by entering the vehicle 4-digit PIN.
If ignition key programming is unsuccessful, the DRBIII® will display one of the following messages:
- Programming Not Attempted
The DRBIII® attempts to read the programmed key status and there are no keys programmed into SKIM memory. - Programming Key Failed (Possible Used Key From Wrong Vehicle)
SKIM is unable to program key due to either; faulty ignition key transponder, ignition key is programmed to another vehicle. - 8 Keys Already Learned, Programming Not Done
SKIM transponder ID memory is full.
- Programming Not Attempted
- Obtain ignition keys to be programmed from customer (8 keys maximum).
- Using the DRBIII®, erase all ignition keys by selecting MISCELLANEOUS and ERASE ALL CURRENT IGN. KEYS.
- Program all ignition keys.
- Learned Key In Ignition
Ignition key transponder ID is currently programmed in SKIM memory.
- Learned Key In Ignition
NOTE:
A maximum of 8 keys can be learned to each SKIM. Once a key is learned to a SKIM it (the key) cannot be transferred to another vehicle.