Fuel Pump Module: Installation
- Wipe seal area of tank clean. Place a new seal between the tank threads and the pump module opening.
- Position fuel pump module in tank. Make sure the alignment marks line up on the fuel tank and pump module.
- While holding the pump module in position, install locknut. Tighten locknut to 74.5 N.m (55 ft. lbs) torque using special tool #6856.
- Install fuel tank, see FUEL TANK .
- Lower vehicle.
- Install the negative battery cable.
- Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
- Fill fuel tank with clean fuel. Use the DRBIII® scan tool to pressurize the system and check for leaks.
NOTE:
The pump has to properly located to the tank for the fuel gauge to work properly.
CAUTION:
Over tightening the pump lock ring may result in a leak.