Electronic Control Modules (Service Information)

• Electronic Control Modules - Service Information
  • Standard Procedure
    • Pcm/SKREEM Programming
      • Notes
      • Programming The Pcm/SKREEM
      • Programming Ignition Keys To The SKREEM
• Module-Antilock Brake
  • Description
  • Operation
  • Removal
  • Installation
• Communication
  • Description
  • Operation
• Door Module
  • Description
  • Operation
    • Notes
    • Anti-Pinch
    • Panic Mode
  • Removal
  • Installation
• Module-Front Control
  • Description
  • Operation
  • Diagnosis And Testing
    • Body Verification Test - VER 1
      • Diagnostic Test
  • Removal
  • Installation
• Module-Seat Memory
  • Description
  • Operation
  • Diagnosis And Testing
    • Memory Seat Module
  • Removal
  • Installation
• Module-Powertrain Control
  • Description
    • Description - Pcm
    • Modes Of Operation
      • Notes
      • Ignition Switch (Key-On) Mode
      • Engine Start-Up Mode
      • Engine Warm-Up Mode
      • Idle Mode
      • Cruise Mode
      • Acceleration Mode
      • Deceleration Mode
      • Wide Open Throttle Mode
      • Ignition Switch Off Mode
    • Description - 5 Volt Supplies
    • Description - Ignition Circuit Sense
    • Description - Power Grounds
    • Description - Sensor Return
  • Operation
    • Operation - Pcm
    • Operation - 5 Volt Supplies
    • Operation - Ignition Circuit Sense
  • Diagnosis And Testing
    • NGC Powertrain Verification Test VER - 1
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 2
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 3
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 4
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 5
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 6
      • Notes
      • Diagnostic Test
  • Removal
  • Installation
• Module-Transmission Control
  • Description
    • Transmission Control Module - 42RLE
    • Transmission Control Module - Nag1
  • Operation
    • Transmission Control Module - 42RLE
      • Notes
      • Battery Feed
      • Clutch Volume Indexes (CVI)
      • Shift Schedules
    • Transmission Control Module - Nag1
      • Notes
      • TCM Signals
        • Notes
        • Selector Lever Position
        • ATF Temperature Sensor
        • Starter Interlock
        • N2 and N3 Speed Sensors
        • CAN Bus Indirect Input Signals
      • Brake Transmission Shift Interlock (BTSI)
      • Shift Schedules
      • Downshift Safety
      • Adaptation
        • Notes
        • Driving Style Adaptation
      • Controller Modes Of Operation
        • Permanent Limp-In Mode
        • Temporary Limp-In Mode
        • Under Voltage Limp-In Mode
        • Hardware Error Mode
        • Loss of Drive
        • Controlled Limp-in Mode
  • Standard Procedure
    • TCM QUICK LEARN - 42RLE Only
    • TCM ADAPTATION - NAG1 Only