Integrated Power Module: Removal

Fig 1: Battery & Cables

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .

Disconnect and isolate the battery negative cable (2).

Fig 2: Disconnecting/Connecting Negative Battery Cable
Courtesy of DAIMLERCHRYSLER CORP.
Open the battery cable nut cover to expose nut.
Remove battery cable nut and battery cable from the Integrated Power Module (IPM).

Fig 3: Integrated Power Module
Courtesy of DAIMLERCHRYSLER CORP.
Disengage the outboard retaining clip, and rotate the IPM to access wire harness connectors.
Disconnect wire harness connectors from IPM.
Disengage the two inboard retaining clips.

Fig 4: IPM Retaining Clips
Courtesy of DAIMLERCHRYSLER CORP.
Remove IPM from vehicle.