LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Driver Airbag >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver Airbag: Installation

Fig 1: DRIVER AIRBAG R/I
GC0013236Courtesy of DAIMLERCHRYSLER CORP.
NOTE: The driver airbag trim cover is available for service separately. If the horn switch is faulty or the trim cover is damaged, the airbag cushion assembly may be transferred to a new trim cover. If the airbag is defective, the entire driver airbag and driver airbag trim cover must be replaced as an assembly.
  1. Position driver airbag (3) in steering wheel (1) near mounting location.
  2. Connect the two airbag squib connectors (2) and the horn connector (4).
  3. Position the driver airbag mounting screws (2) into the driver airbag. From behind the steering wheel (1) install the two screws (5) to the driver airbag. Torque the two screws (5) to 10 N.m (89 in. lbs.).
WARNING: Do not connect the battery negative cable (Refer to ELECTRICAL DIAGNOSTICS - 300 & MAGNUM . Personal injury or death may result if the system test is not performed first.
scientia non olet · About LEMON Manuals