Steering Column Control Module: Installation

Fig 1: SCCM R/I

Courtesy of DAIMLERCHRYSLER CORP.

Install the SCCM (1) onto the steering column.

Fig 2: SCCM SCREW
Courtesy of DAIMLERCHRYSLER CORP.
Tighten the set screw (1) securing the SCCM (2).

Fig 3: CLOCKSPRING SCREWS
Courtesy of DAIMLERCHRYSLER CORP.
Tighten clockspring screws (1) that were backed out to keep the clockspring from unwinding. (Refer to RESTRAINTS - SERVICE INFORMATION ).

Fig 4: STEERING WHEEL
Courtesy of DAIMLERCHRYSLER CORP.
Align the spline on the steering wheel hub to shaft and install the steering wheel (1).
Install a NEW retaining bolt (2). Torque the bolt to 70 N.m (52 ft. lbs.).

Fig 5: AIRBAG R/I
Courtesy of DAIMLERCHRYSLER CORP.
Install the driver airbag (3) (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION) .
Connect the battery negative cable. If equipped with Electronic Stability Program (ESP), the steering angle sensor must be calibrated (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .