LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Engine Performance >> System >> Powertrain Diagnostic Procedures >> System Description And Functional Operation >> Functional Operation >> On-Board Diagnostics >> OBD II Monitor Run Process >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

OBD II Monitor Run Process: Notes

The following procedure has been established to assist Technicians in the field with enabling and running OBD II Monitors. The order listed in the following procedure is intended to allow the technician to effectively complete each monitor and to set the CARB Readiness Status in the least time possible.

NOTE:
  1. Once the monitor run process has begun, do not turn off the ignition. By turning the ignition key off, monitor enabling conditions will be lost. NVLD Monitor runs after key off.
  2. By performing a Battery Disconnect, or Selecting Erase DTCs, the CARB Readiness and all additional OBD II information will be cleared.

Monitor Preliminary Checks: 

  1. Plug a DRB III® into the vehicle's DLC.
  2. Turn the ignition, KEY ON - ENGINE OFF. Watch for MIL lamp illumination during the bulb check. MIL lamp must have illuminated, if not, repair MIL lamp.
  3. On the DRB III® Select #1 DRB III Standalone.
  4. Select #1 1998-2005 Diagnostics
  5. Select #1 Engine
  6. Select #2 DTCs and Related Functions
  7. Select #1 Read DTCs
    • Verify that No Emissions Related DTCs are Present.
    • If an Emissions DTC is Present, the OBD II Monitors may not run and the CARB Readiness will not update.
    • The Emissions related DTC, will need to be repaired, then cleared. By clearing DTCs, the OBD Monitors will need to be run and completed to set the CARB Readiness Status.
  8. Return to Engine Select Function Menu and Select #9, OBD II Monitors.
  9. Select #3 CARB Readiness Status.

    Do all the CARB Readiness Status Locations read

    YES? 

    • YES  , then all monitors have been completed and this vehicle is ready to be I/M or Emission Tested.
    • NO  , then the following procedure needs to be followed to run/complete all available monitors.
NOTE:
  1. Only the monitors, which are not YES in the CARB Readiness Status, need to be completed.
  2. Specific criteria need to be met for each monitor. Each monitor has a Pre-Test screen to assist in running the monitor.

    For additional information, refer to the Chrysler Corporation Technical Training Workbook titled On Board Diagnostics: OBDII/EOBD, part number 81-699-01050.

The most efficient order to run the monitors has been outlined below, including suggestions to aid the process.

scientia non olet · About LEMON Manuals