Integrated Power Module: Installation

Fig 1: Removing/Installing IPM From Vehicle

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .

Position Integrated Power Module (IPM) to vehicle. Engage the three retaining clips.

Fig 2: Disengaging/Engaging Integrated Power Module
Courtesy of DAIMLERCHRYSLER CORP.
Disengage the outboard retaining clip and rotate the IPM to access wire harness connectors.
Connect electrical harness connectors to IPM.

Fig 3: Disconnecting/Connecting Negative Battery Cable from Integrated Power Module (IPM)
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery cable to IPM.
Install and tighten retaining nut.
Close the battery cable nut cover.

Fig 4: Disconnecting/Connecting Battery Negative Cable
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery negative cable (2).