Module-Steering Column Control: Installation

Fig 1: Remove/Install SCCM

Courtesy of DAIMLERCHRYSLER CORP.

Install the SCCM (1) onto the steering column.

Fig 2: SCCM Screw
Courtesy of DAIMLERCHRYSLER CORP.
Tighten the set screw (1) securing the SCCM (2).

Fig 3: Clockspring Screws
Courtesy of DAIMLERCHRYSLER CORP.
Tighten clockspring screw(s) (1) that were backed out to keep the clockspring from unwinding.

Fig 4: Removing/Installing Steering Wheel
Courtesy of DAIMLERCHRYSLER CORP.
Align the spline on the steering wheel hub to shaft and install the steering wheel (1).
Install a NEW retaining bolt (2). Torque the bolt to 70 N.m (52 ft. lbs.).

Fig 5: Removing/Installing Driver Airbag
Courtesy of DAIMLERCHRYSLER CORP.
Install the driver airbag (3) (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION) .
Connect the battery negative cable. If equipped with Electronic Stability Program (ESP), the steering angle sensor must be calibrated (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .