Electronic Control Modules (Service Information)

• Standard Procedure
  • SKREEM Programming
    • Notes
    • Programming The SKREEM
    • ECM/Skim/WCM Programming
      • Notes
      • Programming The Skim
      • Programming Ignition Keys To The SKREEM
• Communication
  • Description
    • Can Bus
  • Operation
    • Can Bus
• Module - Antilock Brake
  • Description
  • Operation
  • Removal
  • Installation
• Module - Door
  • Description
  • Operation
    • Door Module
      • Notes
      • Anti-Pinch
      • Panic Mode
  • Removal
  • Installation
• Module - Engine Control
  • Description
    • Engine Control Module (ECM) Diesel
  • Operation
    • Engine Control Module (ECM) Diesel
    • ECM Operating Modes
      • Notes
      • Ignition Switch On (Engine Off)
      • Engine Start-Up Mode
      • Normal Driving Modes
      • Limp-In Mode
      • OVERSPEED Detection Mode
      • After-Run Mode
    • Monitored Circuits
    • Diagnostic Trouble Codes
      • Notes
      • Hard Code
      • Intermittent Code
      • ECM Diagnostic Trouble Codes
  • Standard Procedure
    • Pcm/ECM Programming - Diesel
      • Pcm / TCM Flash Reprogramming
      • Table Of Contents
      • Section 1 - Pcm / TCM Flash Procedure
      • Repair Procedure - Using STARSCAN® Or STARMOBILE® Desktop Client
      • Repair Procedure - Using STARMOBILE® Standalone Diagnostic Mode
      • Section 2 - Additional Pcm / TCM Replacement Procedures
      • Step-By-Step Instructions
      • Section 3 - Authorized Modification Label
      • Required Tools/Equipment:
      • Tech Tips And Information
      • Parts Required
  • Removal
    • Engine Control Module (ECM) Diesel
  • Installation
    • Engine Control Module (ECM) Diesel
• Module - Front Control
  • Description
  • Operation
  • Diagnosis And Testing
    • Body Verification Test - VER 1
      • Diagnostic Test
  • Removal
    • Module-Front Control
  • Installation
    • Module-Front Control
• Module - Powertrain Control
  • Description
    • Powertrain Control Module (Pcm)
    • Modes Of Operation
      • Notes
      • Ignition Switch (Key-On) Mode
      • Engine Start-Up Mode
      • Engine Warm-Up Mode
      • Idle Mode
      • Cruise Mode
      • Acceleration Mode
      • Deceleration Mode
      • Wide Open Throttle Mode
      • Ignition Switch Off Mode
    • Five Volt Sensor Supplies - Primary And Secondary
    • Ignition Circuit Sense - Pcm Input
    • Power Grounds
    • Sensor Return - Pcm Input
  • Operation
    • Powertrain Control Module (Pcm)
    • Five Volt Sensor Supplies - Primary And Secondary
    • Ignition Circuit Sense - Pcm Input
  • Diagnosis And Testing
    • NGC Powertrain Verification Test VER - 1
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 2
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 3
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 4
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 5
      • Notes
      • Diagnostic Test
    • NGC Powertrain Verification Test VER - 6
      • Notes
      • Diagnostic Test
  • Standard Procedure
    • TCM Quick Learn - 42RLE
    • TCM Adaptation - Nag1
    • Pcm/ECM Programming - Gas
      • Pcm / TCM Flash Reprogramming
      • Table Of Contents
      • Section 1 - Pcm / TCM Flash Procedure
      • Repair Procedure - Using STARSCAN® Or STARMOBILE® Desktop Client
      • Repair Procedure - Using STARMOBILE® Standalone Diagnostic Mode
      • Section 2 - Additional Pcm / TCM Replacement Procedures
      • Step-By-Step Instructions
      • Section 3 - Authorized Modification Label
      • Required Tools/Equipment:
      • Tech Tips And Information
      • Parts Required
  • Removal
    • Powertrain Control Module (Pcm)
  • Installation
    • Powertrain Control Module (Pcm)
• Module - Seat Memory
  • Description
  • Operation
  • Diagnosis And Testing
  • Removal
  • Installation
• Module - Steering Control
  • Description
  • Operation
• Module - Transmission Control
  • Description
    • Transmission Control Module - 42RLE
    • Transmission Control Module - Nag1
  • Operation
    • Transmission Control Module - 42RLE
      • Notes
      • Battery Feed
      • Clutch Volume Indexes (CVI)
      • Shift Schedules
    • Transmission Control Module - Nag1
      • Notes
      • TCM Signals
      • Selector Lever Position
      • ATF Temperature Sensor
      • Starter Interlock
      • N2 And N3 Speed Sensors
      • Can Bus Indirect Input Signals
      • Brake Transmission Shift Interlock (BTSI)
      • Shift Schedules
      • Downshift Safety
      • Adaptation
      • Driving Style Adaptation
    • Controller Modes Of Operation
      • Permanent Limp-In Mode
      • Temporary Limp-In Mode
      • Under Voltage Limp-In Mode
      • Hardware Error Mode
      • Loss Of Drive
      • Controlled Limp-In Mode
  • Standard Procedure
    • TCM Quick Learn - 42RLE
    • TCM Adaptation - Nag1
• Module - Glow Plug
  • Description
  • Operation
  • Diagnosis And Testing
  • Removal
  • Installation