Column Service Information: Shaft-Intermediate: Removal

NOTE: This procedure applies to RHD vehicles only. The intermediate shaft (Z-coupling) on the LHD column is not serviceable.

Fully extend or pull out adjustable steering column (where applicable).
Position the front wheels straight-ahead . Center the steering wheel and lock it in place with a steering wheel holder.
Raise and support the vehicle. Refer to STANDARD PROCEDURE .

Fig 1: Coupling Pinch Bolt At Intermediate Shaft
Courtesy of CHRYSLER LLC
Remove the pinch bolt (3) connecting the intermediate shaft (1) to the steering coupling shaft (2).
Separate the intermediate shaft (1) from the steering coupling (2).
Lower the vehicle.

Fig 2: Intermediate Shaft To Dash Attachment
Courtesy of CHRYSLER LLC
Remove the two retaining nuts (3) securing the intermediate shaft to the dash panel.
Loosen the shaft seal at the dash panel.

Fig 3: Column To Intermediate Shaft Attachment
Courtesy of CHRYSLER LLC
Remove the pinch bolt (3) securing the intermediate shaft to the steering column shaft (1).
Slide the intermediate shaft (2) off the steering column shaft (1) and remove it from the vehicle.