Diagnostic Test
- 1) CHECK FOR CURRENT DTC
Turn the ignition on.
With the scan tool, read PCM DTCs.
Is this DTC present?
Yes
- For complete diagnosis of this DTC, refer to P0137-O2 SENSOR 2/2 ABOVE THRESHOLD .
No
- Go to 2).
- 2) INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
NOTE: Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while checking for shorts and open circuits.NOTE: Check for any Technical Service Bulletins that may apply.Were there any problems found?
Yes
- Repair as necessary.
- Perform POWERTRAIN VERIFICATION TEST - VER 2 .
No
- The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible intermittent condition.