Diagnostic Test

1) FUEL GAUGE OPERATION
Turn the ignition off.

Perform the *FUEL GAUGE INOPERATIVE diagnostic test. Refer to INSTRUMENT CLUSTER FUNCTIONAL TEST .

After performing the *FUEL GAUGE INOPERATIVE test, use the scan tool to erase PCM DTCs.

Turn the ignition off, then back on.

With the scan tool, read PCM DTCs.

Monitor the scan tool for this DTC.

NOTE: It may be necessary to take the vehicle on a test drive.

It may be necessary to take the vehicle on a test drive.

Did this DTC set again?

Yes
1. If the *FUEL GAUGE INOPERATIVE test passed, replace and program the Powertrain Control Module. Refer to REMOVAL .
2. Perform POWERTRAIN VERIFICATION TEST - VER 2 .
No
1. Test Complete.