Ignition Switch

The ignition switch attaches to the lock cylinder housing on the end opposite the lock cylinder. For ignition switch terminal and circuit identification, refer to SYSTEM WIRING DIAGRAMS .

Fig 1: Switch In Dash

Courtesy of CHRYSLER LLC

1. Disconnect negative cable from battery.
2. Remove the Knee Blocker Airbag, refer to REMOVAL .
3. Remove the Instrument Panel Center Bezel, refer to REMOVAL .
4. Remove the 2 switch mounting nuts.
   Fig 2: Ignition Switch Assembly

   Courtesy of CHRYSLER LLC

   1 - Switch Assembly

   2 - Rear Mounting Nut

   3 - Interlock Cable

5. Loosen the rear mounting nut.
6. Slide the assembly rearward.
   Fig 3: SKREEM Module

   Courtesy of CHRYSLER LLC

   1 - SKREAM Module

   2 - Ignition Switch

7. Disconnect the electrical connector from the ignition Switch (1) and SKREEM Module (2).
   Fig 4: Interlock Cable

   Courtesy of CHRYSLER LLC

   1 - Retaining Tab for Cable

8. Remove the interlock cable by depressing the locking tab and pulling straight out.
   Fig 5: Interlock Cable

   Courtesy of CHRYSLER LLC
9. Interlocking cable removed.
   Fig 6: Ignition Key Housing & Switch

   Courtesy of CHRYSLER LLC

   1 - Ignition Key Housing

   2 - Ignition Switch

   3 - Ignition Switch Mounting Screws

   4 - Locking Tabs

10. Remove ignition switch mounting screw.
11. Squeeze the 2 locking tabs to remove ignition switch from the lockhousing