Fuel Level Sending Unit

Release the fuel pressure, refer to FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
Disconnect negative battery cable.
Remove fuel tank, see REMOVAL .
Vacuum area before removing module lock ring.
Disconnect vapor line and electrical connector.

Fig 1: Locking Ring Contact Points
Courtesy of CHRYSLER LLC
Module lock ring contact points.

Fig 2: Module Locking Ring
Courtesy of CHRYSLER LLC
Remove module lock ring.
NOTE: Use a brass punch to remove the 1/4 turn lock ring.
Remove module top.
Tip module on to its side to drain fuel from reservoir in module.
Drain fuel tank, use an approved gasoline draining station.
Disconnect electrical connector for fuel level sending card.

Fig 3: Sending Card Removal
Courtesy of CHRYSLER LLC
Remove fuel level sending card by prying on locking tab and pulling card down toward bottom of the pump module.

Fig 4: Sending Card Locking Tabs
Courtesy of CHRYSLER LLC
There are 2 locking tabs on sending card; one on the front and one on back.