Installation

INSTALLATION

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Connect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in an accidental airbag deployment and possible personal injury.





1. Connect the electrical connector (1) by swinging the retaining bow up.




2. Install the A/C heater control module (2) by pressing in the catch lugs (1) at the sides.




3. Install the center console panel screws (1-2). Center Console - Installation.
4. Install the radio.Installation.
5. Connect the negative battery cable.