Diagnostic Test

REPROGRAM ALL IGNITION KEYS
NOTE: This procedure will clear all the key information from the WCM. It is important to obtain all of the customer's ignition keys so they may be reprogrammed into the module.

NOTE: If the total number of keys already programmed is equal to Eight and another Key is trying to be programmed, this fault is valid. Explain to the customer no more Keys are allowed to be programmed.
1. Turn the ignition on.
2. With the scan tool, clear all the key information in the WCM.
3. Program the all of the customer keys into the WCM (maximum eight).
  Did the "Maximum Number of Keys Programmed" display again?
  
  Yes
  - Replace and program the Wireless Control Module in accordance with the Service Information.
    NOTE: If this vehicle is equipped with a Steering Column Lock Module it must be replaced along with the WCM.
  - Perform the WCM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Wireless Control (WCM) - Standard Procedure
  No
  - Programming of the keys was successful. Test complete.
  - Perform the WCM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Wireless Control (WCM) - Standard Procedure