2.4L Turbo

Fig 1: IGNITION COIL REMOVED

Courtesy of CHRYSLER LLC

Install the coil on throttle body side of the intake manifold, rotate down past the throttle body to the valve cover.

Fig 2: IGNITION COIL REMOVAL/INSTALLATION
Courtesy of CHRYSLER LLC
Rotate coil pack and install under intake manifold.

Fig 3: IGNITION COIL BOLT
Courtesy of CHRYSLER LLC
Install bolts to ignition coil. Twist coil to install 2 of the bolts.
Install coil pack on valve cover. Tighten the bolts to 12 N.m (105 in. lbs.).
Install the spark plug cables to the ignition coil.
Connect the electrical connector to the ignition coil.

Fig 4: THROTTLE CABLE BRACKET
Courtesy of CHRYSLER LLC
Install the throttle cable bracket.

Fig 5: THROTTLE CABLES
Courtesy of CHRYSLER LLC
Install the throttle cables to the throttle body lever.

Fig 6: THROTTLE CONTROL SHIELD
Courtesy of CHRYSLER LLC
Connect the negative battery cable.
NOTE: Check and make sure that throttle body and attachments will not contact ignition cables.
Install the throttle control shield.