SENSOR, Knock: Installation: 3.5L

Fig 1: Knock Sensor Wire Route

Courtesy of CHRYSLER LLC

CAUTION: Always use the specified torque when installing the knock sensor bolt. Over or under tightening the sensor mounting bolt will affect knock sensor performance, possibly causing improper spark control.

Install knock sensor. Tighten knock sensor to 20 N.m (15 ft. lbs.).
Route the knock sensor wire in the proper location.

Fig 2: Knock Sensor Connector
Courtesy of CHRYSLER LLC
Connect the electrical connector.

Fig 3: Upper And Lower Intake Manifold
Courtesy of CHRYSLER LLC
Install the upper and lower intake manifolds. Refer to INSTALLATION .

Fig 4: Identifying Air Cleaner Housing Components
Courtesy of CHRYSLER LLC
Install the air cleaner body. Refer to INSTALLATION .
Connect the negative battery cable, tighten nut to 5 N.m (45 in. lbs.).
Fill cooling system. Refer to Cooling - Standard Procedure .
Operate engine until it reaches normal operating temperature. Check cooling system for correct fluid levels.
Install the engine cover.