Side - B-Pillar Sensor

Fig 1: Removing/Installing B-pillar Impact Sensor

Courtesy of CHRYSLER LLC

Disconnect and isolate the battery negative cable.
WARNING:
Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may result in serious or fatal injury.
Remove the B-pillar lower trim panel. Refer to PANEL, B-PILLAR TRIM, REMOVAL .
Disconnect the electrical connector (4) from the sensor (2).
Remove the screw (3) retaining the B-pillar (1) side impact sensor (2)
Remove the sensor (2) from the vehicle.