Removal & Installation
WARNING: This page is about the Colt Base, which is a different variant/trim than selected.
3 SPEED TRANS
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| | 4.6 | | C |
| Combination Procedure: CLUTCH SEALS: Remove & Replace: |
| Front or Rear | | 1.1 | 1.1 | A |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.5 | 0.3 | C |
| Combination Procedure: KICKDOWN BAND: Remove & Replace: |
| | 0.9 | 0.9 | A |
| Combination Procedure: OIL PUMP: Remove & Replace: |
| Front | | 0.6 | 0.6 | B |
| Combination Procedure: REACTION SHAFT: Remove & Replace: |
| | 0.6 | 0.6 | A |
| Combination Procedure: REVERSE BAND: Remove & Replace: |
| | 1.1 | 1.1 | A |
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: |
| | 1.5 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.2 | 0.2 | C |
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: |
| | 0.6 | 0.4 | C |
4 AND 6 SPEED TRANS
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|
| | 4.6 | | C |
| Combination Procedure: FLYWHEEL: Remove & Replace: |
| | 0.5 | | C |
| Combination Procedure: FRONT PUMP HOUSING SEAL: Remove & Replace: |
| | 0.1 | | B |
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: |
| | 1.5 | | B |
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: |
| | 0.2 | | C |
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: |
| | 0.6 | | C |
| Combination Procedure: TRANSAXLE ASSEMBLY: Reseal: |
| | 1.1 | | B |
| Combination Procedure: TRANSAXLE OIL PUMP: Remove & Replace: |
| | 0.3 | | B |