Cautions & Warnings: Notes

Allow system capacitor to discharge for two minutes before removing airbag components.

DO NOT place an intact undeployed airbag face down on a solid surface, airbag will propel into air if accidentally deployed and could result in personal injury. When carrying or handling an undeployed airbag, trim side of airbag should be pointing away from body to minimize possibility of injury if accidental deployment occurs.

Replace airbag system components with Mopar(R) replacement parts only. Substitute parts may appear interchangeable, but internal differences may result in inferior occupant protection.

Wear safety glasses, rubber gloves, and long sleeved clothing when cleaning powder residue from vehicle after an airbag deployment. Sodium hydroxide powder residue emitted from a deployed airbag can cause skin irritation. Flush affected area with cool water if irritation is experienced. If nasal or throat irritation is experienced, exit vehicle for fresh air until irritation ceases. If irritation continues, see a physician.

DO NOT use a replacement airbag that is not in original packaging, improper deployment and personal injury can result.

The factory installed fasteners, screws and bolts used to fasten airbag components have a special coating and are specifically designed for airbag system. DO NOT use substitute fasteners, use only original equipment fasteners listed in parts catalog when fastener replacement is required.

Airbags should be stored in a cool, dry place, away from excessive heat and static electrical activity with fabric airbag facing up. If not, a premature deployment can result.