LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2004 >> Viper >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Control Modules >> Controller Antilock Brake >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Controller Antilock Brake: Installation

  1. Install CAB onto HCU.
  2. Install four CAB mounting bolts and tighten to 2 N.m (17 in. lbs.) torque (Figure ).
  3. Connect pump/motor wiring connector (Figure ).
    CAUTION: Before installing the 24-way connector in the CAB, be sure the seal is properly installed in the connector.
  4. Install 24-way connector into socket of CAB as follows:
    1. Position 24-way connector in socket of CAB and carefully push it down as far as possible.
    2. Once connector is fully seated into CAB socket, push connector lock inward. This pulls connector into socket of CAB and locks it in place.
  5. Install access panel in forward portion of left front wheel well.
  6. Install tire and wheel assembly (Refer to INSTALLATION - TIRE AND WHEEL ASSEMBLY ). Progressively tighten the wheel mounting nuts in the proper sequence to 122 N.m (90 ft. lbs.) torque.
  7. Lower vehicle.
  8. Reconnect battery negative (-) terminal.
  9. Connect DRBIII(R) to data link connector below steering column to initialize new CAB. Check for any faults.
  10. Road test vehicle to ensure proper operation of ABS.
scientia non olet · About LEMON Manuals