Power Transistor (1.6L)
- Remove connector from power transistor. Using an ohmmeter, place positive lead of ohmmeter to terminal No. 4 and negative lead to No. 6. See Fig 1
. Ensure there is no continuity.
- Using one 1.5-volt dry cell battery, connect positive end of 1.5-volt battery to transistor terminal No. 4. Place positive lead of ohmmeter to terminal No. 4 and negative lead to terminal No. 6 to ensure continuity is present.
- Connect positive end of 1.5-volt battery to transistor terminal No. 2 and negative end of 1.5-volt battery to transistor terminal No. 4. Place positive lead of ohmmeter to terminal No. 4 and negative lead to terminal No. 1. Ensure continuity is present. Replace power transistor if readings are not as specified.
Courtesy of CHRYSLER MOTORS.