LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1990 >> Talon Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Computerized Engine Controls >> Control Unit >> Harness Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Harness Check

  1. If during SELF-DIAGNOSTICS testing Electronic Control Unit (ECU) is found to be faulty, perform the following steps to ensure ECU is faulty.
  2. Most components are incorrectly diagnosed due to faulty electrical connectors or poor connections between component and vehicle.
  3. Sometimes, simply disconnecting and connecting an electrical component will provide a good electrical connection. Before replacing an ECU, check all components in suspect circuit. If components are okay, carefully disconnect ECU from vehicle harness.
  4. Inspect ECU harness connector and ECU contact pins for corrosion. Clean harness connector and ECU contact pins with contact cleaner.
  5. Inspect ECU harness connector for bent pins, missing pins and broken wires. Replace as necessary.
  6. Connect ECU harness connector to ECU and retest system with Diagnostic Readout Box (DRB-II) or similar scan tool. See appropriate SELF-DIAGNOSTICS article. If vehicle does not pass test and fails with the same message, replace ECU.
scientia non olet · About LEMON Manuals