LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1991 >> Talon Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Fuel System >> Control Relay >> 1.8L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Relay: 1.8L

  1. Remove control relay from vehicle. Control relay is located on right side of center console. Disconnect control relay connector. Using an ohmmeter, check for approximately 95 ohms of resistance between control relay terminals No. 3 and 5, and terminals No. 2 and 5. See Fig 1 .
  2. Using an ohmmeter, ensure approximately 35 ohms of resistance is present between control relay terminals No. 6 and No. 7. Ensure there is infinite resistance between terminals No. 1 and No. 4, and between terminals No. 2 and No.4.
  3. Connect positive ohmmeter lead to terminal No. 6 and negative lead to terminal No. 8. Ensure there is infinite resistance. Using an ohmmeter, connect positive ohmmeter lead to terminal No. 8 and negative lead to terminal No. 6. Zero ohms resistance should exist.
  4. While grounding terminal No. 6 and applying battery voltage to terminal No. 8, ensure there is zero ohms resistance between terminals No. 2 and 4.
  5. While grounding terminal No. 6 and applying battery voltage to terminal No. 7, ensure there is zero ohms resistance between terminals No. 1 and 4. Replace control relay if it does not test as described.
Fig 1: Identifying Control Relay Terminal (1.8L)
G90B06314Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals