Entering On-Board Diagnostics Using DRB-II: Notes

1. Before entering on-board diagnostics, refer to PRETEST INSPECTION. Turn ignition off. Attach Mitsubishi Motors Corporation (MMC) cartridge to DRB-II. Connect DRB-II to diagnostic connector. Diagnostic connector is located next to junction block, above left kick panel. See Figure .
2. Ensure all accessories are off. Turn ignition on. All character positions will illuminate and copyright information will appear on screen for a few seconds. Display will then change to DRB-II menu.
3. If DRB-II displays an error message, refer to DRB-II ERROR SCREENS. The following DRB-II modes can be accessed from DRB-II menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.