LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1992 >> Premier ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> DRB-II Test Functions >> Fuel/IGN Menu >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel/IGN Menu: Notes

NOTE: DO NOT touch DRB-II keypad during DRB-II power-up sequence or an error message will result.
  1. In order to perform self-diagnostic tests using DRB-II, DRB-II must be in the FUEL/IGN MENU. At the FUEL/IGN MENU, fault codes and DRB-II test functions can be accessed.
  2. To reach FUEL/IGN MENU, turn ignition off. Connect DRB-II to engine diagnostic connector, located in engine compartment, near SBEC. Turn ignition switch to RUN position.
  3. All DRB-II character positions will glow and copyright information will appear on screen for a few seconds. If screen is blank or any error messages appear, see DRB-II PROBLEMS & ERROR MESSAGES  .
  4. After a few seconds, DRB-II menu will appear. At DRB-II menu, press "4" (SELECT SYSTEM) key. Press ENTER key. At SELECT SYSTEM menu, press "1" (ENGINE) key. Press ENTER key. DRB-II screen will indicate engine year, size, type of transmission and SBEC part number.
  5. After a few seconds, AIR COND menu will appear. Press "1" (WITH A/C) or "2" (WITHOUT A/C). DRB-II display will change to ENGINE SYSTEMS menu. At ENGINE SYSTEMS menu, press "1" (FUEL/IGNITION) key. Press ENTER key.
  6. Display will change to FUEL/IGN MENU. At FUEL/IGN MENU of engine diagnostic program, specific test functions programmed into DRB-II can be performed. The following DRB-II modes can be accessed: SYSTEM TEST, READ FAULTS, STATE DISPLAYS, ACTUATOR TEST and ADJUSTMENTS.
scientia non olet · About LEMON Manuals