AWD Models
- Remove "G" force sensor. See "G" FORCE SENSOR
under REMOVAL & INSTALLATION. Place sensor on level surface. Using an ohmmeter, check continuity between sensor terminals. See Fig 1
. If continuity exists, go to next step. If continuity does not exist, replace sensor.
- Check for continuity between sensor terminals while slowly tilting sensor in direction of forward vehicle travel. See Fig 1
. Continuity should no longer exist once sensor angle is 30 degrees or greater. If sensor tests as specified, go to next step. If sensor does not test as specified, replace sensor.
- Check for continuity between sensor terminals while slowly tilting sensor in direction of reverse vehicle travel. See Fig 1
. Continuity should no longer exist once sensor angle is 30 degrees or greater. If sensor tests as specified, sensor is okay. If sensor does not test as specified, replace sensor.
Courtesy of CHRYSLER MOTORS.