Crank Angle Sensor: Installation
- If reference mark was not made as described in removal procedure, go to next step. If reference mark was made, install distributor by reversing removal procedure, then go to step 3).
- Rotate crankshaft clockwise until piston No. 1 is at TDC of compression stroke. Align punch mark on crank angle sensor housing with notch in plate. See Fig 1
. Install crank angle sensor.
- Adjust ignition timing. See appropriate ADJUSTMENTS
article in the ENGINE PERFORMANCE Section. Tighten crank angle sensor nut to specification. See TORQUE SPECIFICATIONS.
Courtesy of CHRYSLER CORP.