Test 35C - Auto Door Lock Circuit
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- Turn ignition off. Disconnect Body Controller Module (BCM) Bone connector. With DRB-II in voltmeter mode, check voltage on BCM Bone connector terminal No. 9, power door lock switch circuit (Orange/Violet wire). Depress opposite (passenger's) door switch to the lock position. If voltage is less than 10 volts, repair open door lock switch wire. Perform VERIFICATION PROCEDURE VER-1.
- If voltage is more than 10 volts, turn ignition off and reconnect BCM Bone connector. Depress door lock switch to lock position. If doors do not lock, replace BCM. Perform VERIFICATION PROCEDURE VER-1. If doors lock, problem is in driver's door. Repair wiring.