LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Connector Identification >> Test 36D - Remote Keyless Entry (RKE) Module Problem
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 36D - Remote Keyless Entry (RKE) Module Problem

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. If problem is with trunk release or warning light, go to TEST 36E. If problem is not with trunk release or warning light, ensure DRB-II door lock test is still active. Disconnect Remote Keyless Entry (RKE) module Black connector. Module is located on top, right side of dashboard.
    NOTE: RKE module may be accessed by carefully prying each end of dashboard top cover, then lifting rear edge of top cover and sliding cover forward to disengage front clips.
  2. With DRB-II in voltmeter mode, check voltage on RKE Black connector door unlock relay feed circuit (Pink/Violet wire). If voltage fluctuates from zero volts to less than 10 volts, repair open circuit in Pink/Violet wire. Perform VERIFICATION PROCEDURE VER-1.
  3. If voltage fluctuates from zero volts to more than 10 volts, use DRB-II to stop door lock test. With DRB-II in ohmmeter mode, check resistance on RKE Black connector ground circuit (Black wire). If resistance is less than 5 ohms, replace RKE module. Perform VERIFICATION PROCEDURE VER-1. If resistance is more than 5 ohms, repair open circuit in Black wire. Perform VERIFICATION PROCEDURE VER-1.
scientia non olet · About LEMON Manuals