Test 3A - Mic Odometer Problem
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagram, see WIRING DIAGRAMS
at the end of this article.
- Using DRB-II, select engine controller. Using DRB-II, read engine controller faults. If a vehicle speed sensor problem is indicated, refer to appropriate G - TESTS W/ CODES article in the ENGINE PERFORMANCE Section.
- If a vehicle speed sensor problem is not indicated, turn ignition off. Disconnect Mechanical Instrument Cluster (MIC). Check if odometer has been previously replaced. If odometer has not been replaced, replace odometer. Perform VERIFICATION PROCEDURE VER-1. If odometer has been replaced, replace body controller module. Perform VERIFICATION PROCEDURE VER-1.